Table of Contents
Advertisement
5.7 "Main > TS Config" Screen
The "Main > TS Config" screen (Figure 5.7) is a "read and write" screen to assign the TS parameters:
1
5
In the section entitled "Multiplexed MPTS Output Configuration", the user can select and configure the following
parameters of the output TS:
1
TS ID: must enter the identification number for the Transport Stream (TS) output. The range is 1 to 65535.
2
TS Bitrate: When using the encoder's QAM output the "QAM Modulator" setting must be used. The 19.39 and
38.81 Mbps options are only used when precise ASI outputs are desired.
Always select the option "QAM Modulator", if QAM
output is required. The TS Bitrate assigned will then
depend on the "Output QAM Mode" selected on the
"Main > QAM" Screen (refer to
details) and will be as follows:
2
3
6
7
8
11
Figure 5.7 - "Main > TS Config" Screen
5
of Section 5.9 for
4
9
10
QAM Output Mode
TS Bitrate assigned (Mbps)
64B
256B
16A
32A
64A
128A
256A
MPEG-2 Encoder
21
Instruction Manual
26.97
38.81
18.64
23.30
27.96
32.62
37.28
Advertisement
Table of Contents
