Huawei FusionModule1000A20 Product Description page 56

FusionModule1000A20 Prefabricated All-in-One Data
Center
Product Description (380 V)
Indicato
r
ALM
RF_Z
SW Button
Table 3-24 SW button description
Function
Description
Wireless network
RF_Z (802.15.4)
pairing
IP address reset
Issue 01 (2019-10-31)
Color Name
Red Alarm indicator
Green Communication
status indicator
Operation Description
In non-wireless network (802.15.4)
pairing mode, press and hold down the
button for 3s to 5s to enter the wireless
network pairing mode.
In wireless network (802.15.4) pairing
mode, press and hold down the button for
3s to 5s to exit the pairing mode; or the
system automatically exits the pairing
mode after 30 minutes without pressing
the button.
Press and hold down the button for more
than 8s to 20s to clear network
parameters.
Press and hold down the button for 60s to
power on the ECC800. Then the IP
addresses for the ECC800 WAN_1 and
WAN_2 ports will restore to the default
addresses.
Copyright © Huawei Technologies Co., Ltd.
Status Description
intervals blinks at 5 Hz, on for 0.125s and
then off for 0.125s).
Steady on A system failure alarm is
generated.
Off The system is normal.
Blinking at A network is set up, and no
long node access is allowed (the
intervals indicator blinks at 0.5 Hz, on for
1s and then off for 1s).
Blinking at A network is set up, and node
super short access is allowed (the indicator
intervals blinks at 10 Hz, on for 0.05s and
then off for 0.05s).
Indicator Status
The RF_Z indicator is
blinking at super short
intervals.
The RF_Z indicator is
blinking at long
intervals.
The RF_Z indicator is
blinking at super short
intervals.
None
3 System Architecture
50