Protocol Timer: Using the Timer
The SW Rest Secure System™ protocol timer can be utilized to alert the care provider that the
patient needs to be attended to or checked on at intervals of 1, 2 or 4 hours. The protocol timer
has the capability to alert the care provider by an audible tone on the unit and, if connected to the
Nurse Call Interface, can activate the nurse call signal.
WARNING: The bed is to be used in accordance with each facility's policies
and procedures.
Press the PROTOCOL TIMER button once to set the timer to 1 hour, press it twice to set the
timer to set to 2 hours, press it three times to set to 4 hours. By pressing the PROTOCOL
TIMER button a fourth time, the timer will be disabled and no indicator lights will be lit. When
a protocol alarm has been activated, simply press the ENTER button to reset the alarm and repeat
the timing process.
1 Hour
NOTE: On alarm, the unit must first be reset by pressing ENTER before the protocol timer can
be changed.
The sound level on the protocol timer can be changed. For further directions see Set-Up
Instruction Protocol Timer: Sound Level Setting to learn how.
2 Hours
4 Hours
17
Need help?
Do you have a question about the SW Rest Secure System and is the answer not in the manual?