Rockwell Automation Sensia Jiskoot InSpec Remote I/O HUB Installation, Operation & Maintenance Manual page 3

InSpec Remote I/O HUB (ATEX, IECEx)
Important Safety Information
Symbols used throughout the supporting documentation and on the products are defined below:
Symbol Meaning
Dangerous Voltage
Warning/Caution
Protective Earth (Ground)
Functional Earth
Frame or Chassis
Heavy
Static Sensitive Device
(Hand Prohibited)
Disposal:
- Monitoring and Control Instruments, accessories and their packaging should be sorted for
environmental-friendly recycling.
Only for EC countries:
Do not dispose of Monitoring and Control Instruments into household waste! According to the
European Directive 2002/96/EC on waste electrical and electronic equipment (WEEE and its
incorporation into national law, Monitoring and Control Instruments that are no longer suitable for
use must be separately collected and sent for recovery in an environmental-friendly manner.
Tools Required:
-
Tools listed next to this symbol will be required to perform the task outlined in the text that
follows.
Hints & Tips:
-
Text may help answer some questions or aid configuration.
Terms Used in This Manual
WARNING A warning identifies information about practices or circumstances that can lead to personal injury or
death, property damage, or economic loss.
CAUTION Caution statements Indicate actions or procedures which, if not performed correctly, may lead to
personal injury or incorrect function of the instrument or connected equipment.
Note Indicates additional information about specific conditions or circumstances that may affect instrument
operation.
Definition
To indicate hazards arising from dangerous voltages.
An appropriate safety instruction should be followed or
caution to a potential hazard exists.
To identify any terminal which is intended for connection to an
external conductor for protection against electric shock in
case of a fault, or the terminal of a protective earth (ground)
electrode.
To identify an earth (ground) terminal in cases where
Protective or clean Earth (ground) is explicitly required.
To identify a frame or chassis bonding terminal
This product is heavy and reference should be made to the
safety instructions for provisions of lifting and moving.
All precautions against electro-static discharge (ESD) must
be observed to avoid damaging electronic circuits
3