Introduction; Foreword; Warnings - Calorex VPT Series Owners & Installation Manual

OWNER/INSTALLATION MANUAL

1.0 INTRODUCTION

1.1 FOREWORD

Thank you for choosing is product, which is designed
for quiet and energy e cient operation. It is e ideal
way to heat your pool in an environmentally friendly
way.
This guide provides information needed to install and
operate e product effectively. Please ensure you
read is manual and use e correct installation and
operating procedures.
This manual is intended for installers and users.
Read e entire manual before using e heat
pump. Awareness of e correct operating
procedure for e machine and any safety devices
is important, to avoid damage or injury.
The appliance can be used by children aged from 8
years and above and persons wi reduced, physical,
sensory or mental capabilities or lack of experience
and knowledge if ey have been given supervision
or instruction concerning use of e appliance in a safe
way and understand e hazards involved. Children
shall not play wi e appliance. Cleaning and user
maintenance shall not be made by children wi out
supervision.

1.2 WARNINGS

Important safety information is contained in is manual
and marked on e heat pump.
Please read and follow all safety advice.
The refrigerant used in is heat pump is R32.
This refrigerant is environmentally friendly, but
safety instructions must be strictly adhered to.
4
The WARNING sign denotes a hazard. It calls
attention to a procedure or practice, which if not
adhered to could result in injury. Warning signs
and procedures must be complied wi .
If a refrigerant leak is suspected stop using e
heat pump and contact Dan erm Group UK
service.
service.department@dan erm.com
Take e following precautions in order to avoid
any danger:
REFRIGERANT SAFETY:
This heat pump contains R32 refrigerant. Work
on e refrigeration system, repair and disposal
must be carried out by appropriately qualified and
registered engineers.
Repair, service and disposal must be carried out in e
EU by F-Gas registered engineers.
Completely de-gas e refrigerant before any brazing
is performed. Brazing can only be carried out by
technicians trained to EU 517/2014.
Risk assessments must be carried out before
maintenance or repairs are started.
Appropriate safety measures and risk assessments
must be taken before work commences.
Do not attempt to work on e equipment by
yourself.
Consult e qualified engineer undertaking e work to
establish all requirements before work commences.
1005759 ISSUE 3