MobileHelp Fall Button Complete User Manual page 6

Base Station Voice Guidance
Your Base Station has voice announcements. Select announcements are listed below:
Event Voice Prompt
The Base Station is Base Station ON/OFF switch has been turned on, be sure to
"System Ready"
powered on
"Power not detected"
Both red emergency
or "Power detected"
and blue reset buttons
(when electricity is
are flashing
reconnected)
The battery needs Check that the Base Station is correctly plugged into an
"Low Battery"
charging
The emergency call is
"Call in progress" Alarm is being sent to the Emergency Response Center.
initiated
"Please stand by for
Call connected
operator"
"Fall Detected - Press This will occur for about 20 seconds and will allow you time to
Base Station receives a
and hold Button to cancel the alarm. During this time, you may press and hold the
fall signal
Cancel" button on the Fall Button for 5 seconds to cancel the signal.
Fall alarm is canceled "Alarm Canceled"
10
Notes
connect to electric outlet or it will run on battery backup.
Check that the Base Station is correctly plugged
into an electrical outlet.
electrical outlet or it will run on battery backup.
Respond to the Emergency Operator's call over
the device speaker.
Alarm has been canceled.
SRDR-00035 Rev. 1
Complete User Guide
Medication Reminders (optional service):
At the scheduled time for your Medication Reminder, your Cellular Base Station will
■
announce "Medication Reminder, please press reset to accept" and the blue Reset
Button will flash.
The name of the medication will be displayed on the Cellular Base Station screen, just as
■
it was entered in the Connect web portal.
The Base Station will make the announcement once a minute for 30 minutes or until the
■
Reset Button is pressed.
If you press the Reset Button, the reminder will be recorded as accepted. If you do not
■
press the Reset Button within 30 minutes, the reminder will be recorded as ignored.
For complete instructions for Medication Reminders, please log in to Connect web portal
■
and under the "Help" tab, click on "Connect User Guide."
If you have any questions, please call Technical Support.
■
SRDR-00035 Rev. 1
Complete User Guide 11