Advertisement
Quick Links
A U T O M A T I C T R A N S M I S S I O N M U L T I - C H A N N E L R E M O T E S T A R T E R S Y S T E M
AS-1221 / AS-1222
User Guide
It is the responsibility of the vehicle operator to ensure
their vehicle is parked in a safe and responsible manner.
1. When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in
"Park" in order to avoid accidents upon remote starting.
2. It is the user's responsibility to ensure that the remote
starter is disabled or put into valet mode before
servicing.
FCC USER NOTICE (U.S.A.):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.
DOC.1.00
DL Lp
WARNING
November 16, 2006
Manufactured in Canada by Autostart
Advertisement
Related Manuals for Autostart AS-1221
Summary of Contents for Autostart AS-1221
- Page 1 NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment. DOC.1.00 DL Lp November 16, 2006 WARNING Manufactured in Canada by Autostart...
-
Page 2: Table Of Contents
Introduction ...2 Vehicle Presets ...2 Heater and Heated Seat ...2 Windshield Wipers, Radio and Headlights...2 Remote-starting Your Vehicle ...3 Remote-starting ...3 Driving Off ...3 Remote Starter Features...3 Idle Mode ...3 Valet Modes ...3 Panic Mode ...4 Cold Weather Mode...4 Introduction This Module is a state-of-the-art remote car starter system. -
Page 3: Remote-Starting Your Vehicle
Remote-starting Your Vehicle Remote-starting Press the Ι button for approx. 1 second. The parking lights will come on, informing you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The parking lights will remain on during the pre-programmed run time. If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and try to start the engine again. -
Page 4: Panic Mode
To EXIT Valet Mode With the key in the Ignition switch, turn the key to the positions 5 times within 10 seconds. The Parking Light will flash twice indicating the Module is now out of Valet Mode. The LED will turn Valet Mode Using the Valet Button (Available only of the plug-in Valet switch is installed) To put the system into Valet Mode:... -
Page 5: Advanced Features: Installation-Programmable Options
Advanced Features: Installation-programmable options The system was designed with flexibility and OEM integration in mind. With its programmable options, this unit can control nearly any electrical system in your vehicle. Note: The programming of these features should be left to a professional. Changing any one of the settings may adversely affect the operation the Module. -
Page 6: Remote Trunk Release Option
To keep your vehicle protected when the factory security system is disarmed for a remote start, Secure Lock will relock your doors as soon as the vehicle has started. Once the engine run cycle ends, Secure Lock will rearm your factory security system. Remote Trunk Release Option If your system was installed with the remote trunk release, you can open your trunk by pressing buttons Ι... -
Page 7: Limited Lifetime Warranty
Autostart will replace the remote starter module free of charge with a new remote starter module. For the second year after the date of manufacture, as specified by the serial number on the module, Autostart will replace the remote starter module free of charge with a repaired or refurbished remote starter module.