Monitor (Lower End Connectors) - Fagor PPC-21W Series Manual

2.6.2
2.
CNCelite
8060 8065
8070
R . 2106
EF
ꞏ38ꞏ

Monitor (lower end connectors).

Bottom view.
A
(A)T/S RS-232Non-functional on the PPC-21W.
(B)T/S USB Touch screen driver.
(C)24 V DC IN24 V DC supply input (recommended).
(D)12 V DC IN12 V DC supply input (not recommended).
(E)DVI-DNon-functional on the PPC-21W.
(F)VGAVGA video signal input.
(G) Ground connection.
ꞏT/S USBꞏ Touch screen driver.
Connect the monitor's T/S USB (touch controller) output to a USB 2.0 port on the panel PC.
Always use the cable supplied by Fagor for the unit.
ꞏ24 V DC INꞏ Supply input (recommended).
Option recommended by Fagor Automation to power the monitor.
1
ꞏ12 V DC INꞏ Supply input (not recommended).
Fagor Automation recommends 24 V DC power for the monitor. Consult Fagor Automation before using
i
the 12 V DC option.
Both monitor power suppliers (24 and 12 V DC) must never be connected at the same time.
ꞏVGAꞏ VGA Video input.
Connect the panel PC's PCVGA output to the monitor's VGA input. Always use the cable
supplied by Fagor for the unit.
B C D
Ground connection.
G
Plug-in part 3-pole Phoenix-type connector (5.08 mm pitch).
Rated current; 16 A.
Pin Signal. Function.
1 - - -.
2 11 0 V reference signal.
3 +24 V Power supply.
Connector data.
Number of poles.
Pitch.
Connection technique.
Minimum/maximum section.
Rated current In.
Cable data.
Length to be stripped.
See "2.5 Voltage supply for the module."
DC jack connector for the external current adapter. See
"2.5 Voltage supply for the module."
P a n e l P C .
E F
3.
5.08 mm.
Screw connection.
0.2 / 4 mm².
16 A.
7 mm.
on page 36.
on page 36.