Securing The Module - Fagor PPC-21W Series Manual

2.4.3
2.
CNCelite
8060 8065
8070
R . 2106
EF
ꞏ34ꞏ

Securing the module.

The module must be installed in a proper enclosure that may be located on the machine or
on an external support. To insert the unit into the enclosure, it must have a big enough hole
to allow to insert it easily, without obstacles and without forcing the unit. Once the unit has
been inserted into the enclosure, secure it from the inside with the tension jacks. To properly
secure it, use all the tension jacks on the back of the unit. Apply a tightening torque of 0.7 Nm.
Mounting the equipment.
Follow the instructions below.
1 Before inserting the equipment inside the enclosure, use the two upper screws (A) to
attach the temporary fastening hooks (B) in the desired position. These hooks facilitate
the assembly by temporarily securing the module until it is permanently supported at the
rear using the 12 fastening attachments. These two hooks should never be used as the
final attachment fixture.
A
2 Adjust the two lower stop screws (C) to hold the PPC-21W at the correct height.
C
B
P a n e l P C .