Chapter 1 Previous Information - Fagor PPC-21W Series Manual

P a n e l P C .
1 PREVIOUS INFORMATION.
About this manual.
This manual describes the characteristics, technical data and connections of the hardware
associated with the CNC. The installation manual describes the CNC configuration, machine
adaptation and start-up.
Installation and startup.
The hardware described in this manual is ready to be used in industrial environments
complying with the directives and regulations effective in the European Community. Before
start-up, verify that the machine that integrates this CNC meets the 89/392/CEE directive.
Safety conditions.
In order to avoid personal injuries and damage to this product or to those connected to it,
read carefully the section on safety conditions in the introduction to this manual. Fagor
Automation shall not be held responsible of any physical damage or defective unit resulting
from not complying with these basic safety regulations.
Do not handle the connectors with the unit connected to AC power. Before doing it, make sure that
the unit is unplugged from the power outlet.
Do not get into the inside of the unit. This unit MUST NOT be opened by unauthorized personnel. Only
personnel authorized by Fagor Automation may manipulate the inside of this unit.
1.
CNCelite
8060 8065
8070
R . 2106
EF
ꞏ25ꞏ