Route Calculation - Bosch AIVIH61L2 Manual

ROUTE CALCULATION

. There may be cases where carpool
lanes are included on a suggested
route when the automatic rerouting
function is activated, even if the [Time
Restricted Roads] is set to [Use Re-
striction Info] or [Avoid].
"Route Preference" (page 6-16)
. The suggested route may not be the
shortest, nor are other circumstances
such as traffic jams considered.
. Because of the inevitable difference in
road conditions and circumstances
between the time you use this system
and the time the information was
produced for the map data, there
may be discrepancies in roads and
regulations. In such cases, actual road
conditions and regulations take pre-
cedence over map data information.
. During route calculation, the map will
not scroll, however the vehicle icon will
move according to the actual vehicle's
movement.
. In some cases, after the calculation is
complete, the calculated route may
not be immediately displayed.
. Waypoints that have been passed will
be disregarded by rerouting calcula-
tion.
Condition:
. If you scroll the map while the sug-
gested route is being drawn, it may
take more time to finish drawing.
. Route calculation may not be com-
pleted in the following cases.
— If there is no main road within a
range of 1.5 miles (2.5 km) from the
vehicle, a message saying so will
appear on the screen. Try recalcu-
lating when the vehicle is closer to a
main road.
— If there is no main road within a
range of 1.5 miles (2.5 km) from the
destination or waypoint, a message
saying so will appear on the screen.
Try setting the location closer to a
main road.
— If the vehicle is too close to the
destination or if there are no roads
to the destination, a message say-
ing so will appear on the screen.
— If it is impossible to reach the
destination or waypoints because
of traffic regulations, etc.
— If the only route to reach the desti-
nation or waypoints is extremely
complicated.
. The following may occur when the
route is displayed.
[ Edit: 2019/ 9/ 13 Model: 2020MY AIVI ST3 OM_N20E-AV1NJU0_NAVIOM19-022 ]
(149,1)
6. Navigation (if so equipped)
— If you calculate a route on a main
road, the starting point of the route
may not exactly match the current
vehicle location.
— The endpoint of the route may not
exactly match the destination.
— If you calculate a route on a main
road, the system may display a
route from another main road. This
may be because the position of the
vehicle icon is not accurate. In this
case, park the vehicle in a safe
location and reset the vehicle icon,
or continue driving to see if the
position of the vehicle icon is auto-
matically adjusted before recalcu-
lating the route.
— There are cases in which the system
shows an indirect route to reach
the destination or waypoints, if you
set them from stored or facility
information. In order to correct this,
you must be careful about the
traffic direction, especially when
lanes with different travel directions
are shown separately, such as inter-
changes and service areas.
— This system makes no distinction
between limited traffic control and
total control (blockage). It may
show an indirect route even if the
6-43