Route Calculation And Visual Guidance - Bosch AIVIH61L2 Manual

8. Troubleshooting guide

ROUTE CALCULATION AND VISUAL GUIDANCE

Symptom
Waypoints are not included in
the auto reroute calculation.
Route information is not dis-
played.
The auto reroute calculation (or
detour calculation) suggests the
same route as the one pre-
viously suggested.
A waypoint cannot be added.
The suggested route is not dis-
played.
A part of the route is not dis-
played.
8-22
Condition:
Possible cause
Waypoints that have been already passed are not included
in the auto reroute calculation.
Route calculation has not yet been performed.
The vehicle is not on the suggested route.
Route guidance is turned off.
Route information is not provided for certain types of
roads.
Route calculations took priority conditions into consid-
eration, but the same route was calculated.
Twenty waypoints are already set on the route, including
ones that the vehicle has already passed.
Roads near the destination cannot be calculated.
The starting point and destination are too close.
The starting point and destination are too far away.
There are time restricted roads (by the day of the week, by
time) near the current vehicle location or destination.
The suggested route includes narrow streets.
[ Edit: 2019/ 9/ 13 Model: 2020MY AIVI ST3 OM_N20E-AV1NJU0_NAVIOM19-022 ]
(192,1)
Possible solution
To go to that waypoint again, edit the route.
Set the destination and perform route calcu-
lation.
Drive on the suggested route.
Turn on route guidance.
This is not a malfunction.
This is not a malfunction.
A maximum of 20 waypoints can be set on the
route. To go to 21 or more waypoints, perform
route calculations multiple times as neces-
sary.
Reset the destination to a main or ordinary
road, and recalculate the route.
Set a more distant destination.
Divide the trip by selecting one or two
intermediate destinations, and perform route
calculations multiple times.
Select [Do Not Use Restriction Info] in the
[Time Restricted Roads] setting.
"Route Preference" (page 6-16)
This is not a malfunction.