Current SILENT TRAC Setup Manual page 7

In some instances it may become necessary to remove your drapery from the network. Removing the drapery from the network

will remove the drapery from the bridge and you will need to re-add it back to your network before you can use the remote or

app.

1. DISCONNECT POWER

Disconnect power from the unit. For hardwired units, simply

unplug the device. For battery powered units, remove the battery

tube by twisting it off of the connection wire. See Figure 26.

With power disconnected, pull down on the Pendant or cord and

release once. See Figure 27.

2. SETUP THE DRAPERY FOR MASTER RESET

Move the drapery to a position halfway between full open and full

closed. See Figure 28.

3. RECONNECT POWER

Reconnect power to the unit by plugging the unit back in or by

reconnecting the battery tube. See Figure 29.

4. PERFORM MASTER RESET

Pull down on the Pendant and hold for 10 seconds or until the

drapery jogs. See Figure 30.

Your drapery has now been removed from the network.

IV. Remove the drapery from a network

Figure 26 - Disconnect power

Figure 27 - Pull down and release Pendant or cord once

Figure 28 - Move drapery to halfway between open & closed position

Figure 29 - Reconnect power

Figure 30 - Pull down and hold Pendant for 10 seconds