Current SILENT TRAC Setup Manual page 5

3. PAIR DRAPERY
On any drapery that you would like to pair to the bridge, pull down
and release the Pendant once to start the drapery, then once again
to stop it. See Figure 12.
The green LED on the bridge will flash to indicate the drapery has
been paired. The drapery will jog to confirm. See Figure 13.
Repeat Steps 2 & 3 for all remaining devices.
If the drapery does not jog, try putting the drapery into pairing
mode again. You have 5 minutes until the bridge times out of
pairing mode.
If the pairing is not successful again, try a Master Reset on the
drapery.
1. PAIR REMOTE TO BRIDGE
If using the Current Products Corp. bridge, use a tack or paperclip
to press and hold down the button on the bottom of the bridge for
5 seconds. After 5 seconds, release the button to put the bridge in
pairing mode. See Figure 14.
The LEDs on the bottom of the bridge will flash blue to confirm that
it is in pairing mode. Then press and hold again until the LEDs flash
blue again. See Figure 15.
III. Pair the Remote to the drapery (Zigbee)
Figure 12 - Pull down and release the pendant twice
LEDs
Figure 13- LED will flash green.
Figure 14 - Press and release the back button on the bridge
LEDs
Figure 15 - LEDs will flash blue.
5
2x
Flashing Blue
Solid Blue
Join Mode
Bluetooth Enabled
Solid Green Flashing Green
Connected to Server Command Received
Solid Red
Flashing Red
No Internet
Not Registered/Error
Flashing Blue
Solid Blue
Join Mode
Bluetooth Enabled
Solid Green Flashing Green
Connected to Server Command Received
Solid Red
Flashing Red
No Internet
Not Registered/Error