Current SILENT TRAC Setup Manual page 4

1. POWER THE BRIDGE
Find an outlet in a location central to the drapery that you are
installing in the home. Insert the micro-usb end of the included
power cable into the power port on the bridge. Plug the other end
of the cable into an outlet. See Figure 8.
The LEDs on the bridge will flash red and green and then turn solid
red. See Figure 9.
2. PUT BRIDGE IN PAIRING MODE
Push a tack or paperclip into the hole in the back of the bridge and
press and hold the button for 5 seconds or until the LED begins to
flash blue, then release the button. See Figure 10.
The LED will flash blue and then turn solid red. After that, the LEDs
will stay red. See Figure 11.
II. Setup with the bridge Only (No App)
Figure 8 - Plug in the bridge
LEDs
Figure 9 - LEDs will flash red and green, then turn solid red.
Fig 10 - Press and release the button on the back of the bridge
LEDs
4
Solid Blue
Bluetooth Enabled
Solid Green
Connected to Server
Solid Red
No Internet
Solid Blue
Bluetooth Enabled
Solid Green
Connected to Server
Solid Red
No Internet
Figure 11 - LED Indicators
Flashing Blue
Join Mode
Flashing Green
Command Received
Flashing Red
Not Registered/Error
Flashing Blue
Join Mode
Flashing Green
Command Received
Flashing Red
Not Registered/Error