Current SILENT TRAC Setup Manual page 6

Pull the "Pull" tab from the bottom of the remote you would like to
pair to the drapery (if the tab has already been removed, press and
release any button on the remote face). The LEDs on the front of
the remote will scroll back and forth to show it is seeking a bridge
to connect to. See Figure 16.
When the remote successfully joins the network, the LEDs on the
remote will have an alternating flash. If the remote does not find
and join the network, the lights will turn off after 10 seconds.
2. INITIATE PAIRING MODE ON DRAPERY
Pull down and release the Pendant twice to enter learn mode.
After the first tug, the drapery should start moving. The second tug
should stop it. See Figure 17.
3. PAIR REMOTE TO DRAPERY
On multi-channel remotes, select the channel you wish to pair to
by pressing the Channel button until the LED corresponding with
the appropriate channel is lit. See Figure 18.
Depress the "pairing" button on the back of the remote by pushing
a tack or paperclip through the hole in the back of the remote.
See Figure 19. The LEDs on the front of the remote will scroll to
confirm it has entered pairing mode.
Press and release the top left button on the remote. The drapery
will jog to confirm pairing has been successful. See Figure 20.
Figure 16 - Remove the pull tab or press any button on the face of the
2x
Figure 17 - Pull down and release the Pendant twice
Figure 18 - Press the channel button until the
desired channel is selected
Figure 19 - Depress and release the back button on the remote
Figure 20 - Press and release the top left button to pair
6
remote.