Tripod Data Systems SURVEY PRO User Manual page 326

User's Manual – GPS Mode
Note: You should not use this routine to connect to a VRS service
that does not use an NTRIP logon procedure. (This workflow is only
supported in the standard GPS module.)
Select NTRIP Services Screen
Once connected, tap the desired NTRIP service.
Enter your User Name and Password if the
selected service requires them and then tap
Connect >. You can now complete your GPS
setup.
Setup Rover Screen
This feature is the same as the Set Rover
screen (Page 314).
Setup Remote Base
1. The Setup Remote Base screen can have three different
states, which are the same as the Setup Base Point screen
described on Page 313.
The button at the bottom right of the page will say Next >
when the projection is not fully set and solved for this survey.
The button at the bottom right will say Finish if the projection
is solved.
2. Verify the correct antenna height is displayed on this screen
and tap one of the following:
•
Tap Next > to write the base and rover setup raw data
and advance to the Solve Projection routine.
• Tap Finish to write the base and rover setup raw data,
closes the start survey wizard and opens data collection or
stake out.
316