Tripod Data Systems SURVEY PRO User Manual page 251

Base Setup Two – SET
The Base Setup Set screen is used when the geodetic coordinate of the
chosen base reference point is known or can be calculated.
session.
Base Setup Two - GET and SET
The Base Setup GET and SET screen is used when the geodetic
coordinate of the base reference position is not known. In this case,
you must GET an autonomous position from the GPS receiver, then
you can SET this as the reference position.
5. Tap SET to start the base receiver
broadcasting this reference position and
GPS observations over the radio link, and
to configure the base reference position in
Survey Pro.
Note: If you have post processing data
collection turned on, the receiver will now open
a file (with the next available default name),
start recording GPS raw data, and record the
station and antenna information for this static
6. Tap GET Position From Rx to get an
autonomous position from the receiver. If
you wish to get an averaged position, enter
a number in Average position [n] epochs
before GET.
7. Check the results displayed in the edit
boxes. If it looks good, tap SET to start the
base receiver broadcasting this reference
position and GPS observations over the
radio link, and to configure the base
reference position in Survey Pro.
GPS Module
241