Heat & Glo TRUE-36S-IFT Installation Manual page 64

TOP OF BURNED TOP OF BURNED
AREA NEAR LOG #1 AREA NEAR LOG #1
1 1
2 2
LOG RESTING IN NOTCH LOG RESTING IN NOTCH
Figure 6.
Log #3 (2282-703): Locate log placement areas for Log #3. See Figure 5. Place Log #3 into notch on Log #1 so that the
base rests on the fl at area of log #2. The top of the burned area on Log #3 will be close to Log #1 when properly positioned.
See Figure 6.
Log #4 (2282-704): See Figure 7. Place Log #4 between the left and center grate tines. The base of Log #4 should rest on
the refractory. Notch on log will rest on the front left grate tine and the top of log will rest in notch on Log #2. See Figure 8.
NOTCH FOR LOG #5 NOTCH FOR LOG #5
LOG RESTS ON REFRACTORY LOG RESTS ON REFRACTORY
LOG NOTCH LOG NOTCH
CONTACTS CONTACTS
LEFT GRATE TINE LEFT GRATE TINE
Figure 8.
Log #5 (2281-705): Locate fl at area on Log #4 that will be used to position Log #5. See Figure 8. Place Log #5 into appli-
ance as shown in Figure 9. The left side of the log will rest on bottom refractory and pilot bracket. It will also lean against
rear grate tine. The right side of Log #5 will rest in notch on Log #4. There will be a space approximately 1-3/4 inches from
the end of the log to the left side refractory.
64 Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. B • 2/17
3 3
LOG RESTS ON LOG #2 LOG RESTS ON LOG #2
4 4
5 5
Figure 7.
LOG RESTS ON PILOT LOG RESTS ON PILOT
BRACKET AND LEANS BRACKET AND LEANS
AGAINST REAR GRATE AGAINST REAR GRATE
TINE TINE
1-3/4 IN. 1-3/4 IN.
LOG RESTS ON BOTTOM REFRACTORY LOG RESTS ON BOTTOM REFRACTORY
Figure 9.
4 4
NOTCH NOTCH
LOG RESTS ON LOG #4 LOG RESTS ON LOG #4
5 5
4 4