Installing Non-Combustible Facing Material - Heat & Glo TRUE-36S-IFT Installation Manual

C. Installing Non-Combustible Facing Material
WARNING! Risk of Fire!
• Follow these instructions exactly.
• Facing materials must be installed properly to prevent
fi re.
• No materials may be substituted without authorization
by Hearth & Home Technologies.
• The fi nishing templates are shipped fastened to the top
surround. Remove fi nishing templates prior to installing
non-combustible board.
• Remove non-combustible facing pieces from back of
appliance. See Figure 6.7.
• Install non-combustible facing material to the appliance
using the screws supplied in the manual bag assembly.
• Center and attach two top boards to the framing
members. See Figure 6.8.
• Attach left and right side pieces to framing members.
• Use fasteners from fastener packet (in manual bag) for
screws that secure to the fi replace. See Figure 6.8.
• Use regular sheetrock screws or nails to secure the
perimeter of the non-combustible facing materials to the
wood framing. See Figure 6.8.
• Use a wet or dry towel or soft brush to remove dust or
dirt from facing material.
• See Section 10 for fi nishing materials guidelines.
Figure 6.7 Shipping Location of Non-Combustible Board
36 Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. B • 2/17
PERIMETER:
SECURE TO FRAMING WITH
DRYWALL SCREWS OR NAILS
(NOT INCLUDED)
INTERIOR:
SECURE WITH
SELF-TAPPING SCREWS
(IN MANUAL BAG ASSEMBLY)
Figure 6.8 Installing Non-Combustible Facing Material