Connections Overview; Transducer Cable Connection - Raymarine DownVision CPT-70 Installation Instructions Manual

4.3 Connections overview

Use the following information to help you identify the connections
on your product.
Connector Connector type
CPT-60 / CPT-70 /
CPT–80 Transducer
and display power
CPT-100 /
CPT-110 / CPT-120
Transducer
Cables and connections

4.4 Transducer cable connection

The transducer can be connected directly to a DownVision sonar
module or a DownVision variant multifunction display.
Follow the Cables and Connections chapter of the manual
Connects to:
that accompanied your sonar module or DownVision variant
Dragonfly display
multifunction display to make the appropriate connections.
Making connections
Follow the steps below to connect the cable(s) to your product.
1. Ensure that the vessel's power supply is switched off.
2. Ensure that the device being connected to the unit has
Sonar module or
compatible multifunction
3. Ensuring correct orientation, push the cable connector fully
display.
4. Turn the locking collar clockwise to secure the cable.
Transducer cable extension
For some installations it may be necessary to extend the
transducer cable.
• Refer to
• Raymarine recommends a maximum of one cable extension
• For best performance, keep all cable lengths to a minimum.
been installed in accordance with the installation instructions
supplied with that device.
onto the corresponding connector on the unit.
Chapter 11 Spares and accessories
suitable transducer extension cables.
for any single transducer cable.
for a list of
21