2. Disconnect any interface cables from the back of the
printer.
3. Use a Phillips-head screwdriver to remove the two screws
securing the interface cover. Then lift off the cover.
4. Set any switches and jumpers on the interface board as
described in its manual. If your board has a jumper labeled
JG, make sure that you set it to
work properly.
5. Slide the interface board along the slots on both sides of the
compartment. Push it in firmly to fully insert the board's
connector into the printer's internal socket.
6. Secure the interface board in the slot with the two screws
included with the board.
A-3
Using Optional Interfaces
, or the board will not
ON