Supermicro SuperServer 510P-M User Manual page 59

NC-SI Header for IPMI Support
A Network-Controller Sideband Interface (NC-SI) header is located at JNCSI1 on the
motherboard. For remote management, connect the appropriate cable from this header
to an add-on card to provide the out-of-band (sideband) connection between the onboard
Baseboard Management Controller (BMC) and a Network Interface Controller (NIC). For
the network sideband interface to work properly, you will need to use a NIC add-on card
that supports NC-SI and also need to have a special cable. Please contact Supermicro at
www.supermicro.com to purchase the cable for this header. Refer to the table below for pin
definitions.
Intel RAID Key Header
The JRK1 header allows the user to enable RAID functions for NVMe connections. Refer to
the table below for pin definitions.
NC-SI Header
Pin Definitions
Pin# Definition Pin# Definition
1 Clock 2 GND
3 CRS_DV 4 GND
5 RX_D0 6 GND
7 RX_D1 8 GND
9 TX_D0 10 GND
11 TX_D1 12 GND
13 TX_EN 14 GND
15 ARB_IN 16 ARB_OUT
17 Power 18 Power
19 Power 20 Power
21 Power 22 NC
Intel RAID Key Header
Pin Definitions
Pin# Defintion
1 GND
2 PU 3.3V Stdby
3 GND
4
PCH RAID KEY
59
Chapter 4: Motherboard Connections