Awenta COSY CM100 Operation And Assembly Manual

COSY CM100
Operation and
assembly manual.
Operation and assembly
manual should be carefully
read and kept at hand to be
referred to at any time.
NOTICE: Safety guidelines:
•
Do not use the device against
its intended use.
•
The device may be used only with closed sources of heat which do not
generate harmful substances, exhaust etc. (closed fireplace or furnace)
•
The assembly of the ventilator should be performed only by a specialist
electrician bearing in mind regulations concerning the installation.
•
Electrical installation must be equipped with a switch in which the distance
between contacts is at least 3 mm.
•
Before commencing the assembly and doing maintenance switch off the
power of the device and secure from undesirable switching on.
•
Ventilators of this series of types are meant only for household use and
similar; do not use for business activity and/or industrial purposes.
•
During preparation of the electrical installation and assembly of the devices
observe domestic regulations concerning the installation.
•
Ventilators are meant to work at air temperature from 0 to 40 °C.
•
Assembly height of the ventilator should be at least 2,3 m above the floor.
•
It is forbidden to use the ventilator in a situation where there is a danger of
foreign bodies entering the ventilator air stream. They may damage the rotating
parts or even lead to the ventilator jamming.
•
Ventilator should be assembled in ventilation ducts free from exhaust and
other gases, as well as aggressive factors.
•
Adequate measures should be taken to prevent reverse flow of gases to a
room from an open ventilation duct or other devices with open fire!
•
These devices are not meant to be operated by persons (including children)
with limited manual, sensual or intellectual abilities or persons who do not have
experience and/or have sufficient knowledge, unless they remain under
supervision of a person responsible for their safety or are trained by that person
to operate these devices.
EN