Denver SCO-80100 Original Instruction page 30

Regarding Battery charging SCO-80100
Important – Please read!
Dear customer. We hope you get a lot of joy out of your new E-scooter.
The battery type in these kinds of E-scooters are not fully charged from production line.
And when left unused they can slowly discharge by themselves.
This can lead to slow charge if the batteries are fully discharged, but this is done to avoid
damage to the battery cells.
If you experience that you cannot turn on your E- scooter , and it doesn't seem to charge
(the charger light up green instantly), then please do the following.
Leave the charger in for 6-7 hours. This will make sure the battery will be fully
1.
charged again (it can take 3-4 hours before it starts normal charging).
If this does not solve your problem, please ride the E-scooter manually without
2.
turning it on. Use your legs to give speed, for around 100 m, and then connect the
charger. The engine in the front wheel will this way help to activate the charging
function and it will charge normally. (fully charge takes 2-3 hours if using this way)
For "MD DOC" document, please refer to a separated leaflet.
Please enter: www.denver-electronics.com to obtain the electronic version of the
manual.