Denver SCO-80100 Original Instruction page 18

Gear
Time
Single Mileage
Power On: Long press the power button until the display lights up.
Power Off: Long press the power button until the display goes out and the system is off.
1. Battery power display: it shows the current remaining battery capacity.
2. Power Off Automatically: After the display stops working (acceleration/deceleration and buttons)
for more than 5 minutes, the E-scooter automatically turns off.
Showing Data Switch: When the E-scooter is on, short press the power button , change the
showing data on the display, TIME, ODO, DIS and other characters respectively. When it is showing time,
it indicates the running time after switching on. The time will be cleared after switching off. When it is
showing DIS, it indicates the driving distance after switching on, and it will be cleared after power off.
When it is showing ODO, it indicates the total mileage, which will be retained unless it is manually
cleared.
Change the gear: Short press ▲ the Speed up Button and the ▼ Speed down Button, change the gear
level( Gear 3 is fast speed, Gear 2 is medium speed, and Gear 1 is slow speed).
Acceleration: Gently press the accelerator dial to speed up(The depth of the press is related to the
gear).
Deceleration: Gently press the deceleration dial to slow down. The deeper the press, the greater the
deceleration (the deceleration is relevant to the formation of the press, and pushing too hard can not
increase the braking force and may cause damage to the brake dial).
Total mileage clearance: press ▲ and ▼ buttons at the same time , then press the power button
to switch on the E-scooter, and the total mileage will be cleared.