Table of Contents
Advertisement
Charge the device only at temperatures between 0 °C and +45 °C.
•
When charging at lower or higher temperatures, there is a risk that the battery performance will
•
be reduced; therefore, there is a potential risk of injuries and material damage.
Store and charge the device in an open, dry area away from combustible materials.
•
Do not charge the device in direct sunlight or in the vicinity of open flames.
•
Do not charge the device immediately after use. Allow the device to cool down for an hour
•
before charging it.
If the device is left to other people, it must be charged partially (20 - 50%), not fully.
•
Do not remove the device from its package to fully charge it and then put it back in the package.
•
The device is generally partially charged as shipped from the factory. Keep the device partially
•
charged until it is used.
Allow the E-scooter to cool down for at least 1 hour before it can be put in the package.
•
Do not leave the device exposed to sunlight in a car.
•
The E-scooter must not be used during the charging cycle!
The LED indicator on the battery charger lights red during the charging process.
•
The LED indicator on the charger will light green when the charging process is complete.
•
After charging, disconnect the charger from the mains and the E-scooter.
•
Connect the DC cable supplied with the E-scooter only to the DC input!
Do not insert foreign bodies into the DC input.
•
Do not remove the protective cap from the DC input!
•
Remove the cap only when charging the e-scooter!
•
After charging, disconnect the DC plug and close the DC input again with the cap!
•
Make sure that neither water nor other liquids penetrate into the inner components of the E-scooter;
otherwise, the electronics/batteries of the device could be permanently damaged. There is a risk of
injury.
Advertisement
Table of Contents
