Denver SCO-80100 Original Instruction page 15

Please notice:
a period of time. Expect between 90 and 120 days in off mode if batteries are fully charged. If
only partially charged, this period of time is lower.
Please make sure to charge the batteries before they are 100% out of power, to avoid damaging the
battery cells. (damaged battery caused by wrong handling are not covered by warranty)
It is forbidden to disassemble battery package. This is only to be handled by official service repair
centers and professionals.
Maintaining bearings
•
The E-scooter has sealed and dustproof bearings so that no lubrication is required. Check the
bearings for wear at regular intervals to avoid unsafe riding. Do not jump on and off and do not
apply excessive force otherwise to avoid damage to the bearings. This is not a sports E-scooter.
Maintaining wheels
•
Check the wheels for wear at regular intervals to avoid unsafe riding.
Maintaining the brake
•
The brake pad is made of plastic. Check the brake pad for wear at regular intervals to avoid unsafe
riding. Do not apply excessive force to avoid damage to the brake. When the brake pad wear
1.3mm, need to be replaced.
Maintaining screws and other fasteners
•
Make sure that all screws are properly tightened to avoid unsafe situations. Be sure to grease the
moving parts at regular intervals to ensure the best possible riding experience.
Please make sure to check that the steering system is correctly adjusted and that
•
all connection components are firmly secured and not broken before riding, refer to
handlebar assembly and safety instruction.
Please read operation guide and warnings of correct techniques for use and
•
braking
Aalways wear shoes;
•
When self-locking nuts and other self- locking fixings may lose their effctiveness
•
Even fully charged batteries will run out of power if the E-Scooter is not used for