Alerts Settings; Units Of Measure Settings; Network Settings - Simrad R5000 Commissioning Manual

Ignore position quality
Allows using EPFS sensors with legacy NMEA messages.
Without this option activated the system will not consider these legacy EPFS sensors. Data
will be ignored and a speed log error alarm will be raised.

Alerts settings

Siren enabled
By default, the audible alert signal is turned ON.
You can select to disable the audible signal when service mode is active, but the audible
signal will be enabled when service mode is deactivated.
Alerts
Displays a list of all active and historical alerts with time stamp.
Test alarm
Tests the alert indicator and audible signal. When it is ON an alert starts to sound and the Test
alarm appears on the Alerts panel. It can be acknowledged but remains on the panel until it
is turned OFF in the settings menu.

Units of measure settings

By default, speed measurements are in knots (kn), and large range measurements are in
nautical miles (NM). These settings cannot be changed.
For distances below 0.125 NM you can select to show the distance in meters.
Ú Note:
Units of measurements can only be changed when the connected antenna is in
standby mode.

Network settings

Software setup | R5000 Commissioning manual
27