Replacing The Power Distribution Board - IBM 7063-CR2 Manual

Replacing the power distribution board in the 7063-CR2 system
To replace the power distribution board in the IBM Power Systems HMC (7063-CR2) system, complete
the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Use the two finger grips to lift the power distribution board and set the power distribution board into
the system.
3. Replace the 19 screws to secure the power distribution board to the system.
46 Power Systems: Servicing the IBM Power Systems HMC (7063-CR2)