Table of Contents
Advertisement
IBM Ethernet Appliance J34S Getting Started Guide
Connect the IOC Cables
1.
2.
WARNING: Class 1 laser product.
WARNING: Do not look directly into a fiber-optic transceiver or into the ends of
fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a
transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when inserting
or removing cable. The safety cap keeps the port clean and prevents accidental
exposure to laser light.
3.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend radius. An arc
smaller than a few inches in diameter can damage the cable and cause problems
that are difficult to diagnose.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do not allow
fastened loops of cable to dangle, which stresses the cable at the fastening point.
Step 5: Connect the Ground and Power Cables
Depending on your configuration, your device uses either AC or DC power supplies.
Perform the appropriate procedures for each power supply in your device.
14
Step 5: Connect the Ground and Power Cables
Have ready a length of the type of cable used by the IOC. For cable specifications,
see the IBM Ethernet Appliance J34S Hardware Guide.
If you are connecting a fiber IOC cable, the connector port may be covered by
a rubber safety cap. If it is, remove the cap.
Insert the cable connector into the cable connector port on the IOC faceplate.
Advertisement
Table of Contents
