Operator Console Cable - IBM 7063-CR2 Manual

Figure 4. Connecting the drive signal cable
3. Install the service access cover.
For instructions, see "Installing the service access cover on a 7063-CR2 system" on page 105.
4. Replace the system in the rack and replace the components that you removed.
For instructions, see "Placing a 7063-CR2 system into the operating position" on page 103.
5. Power on the system for operation.
For instructions, see "Starting the 7063-CR2 system " on page 98.
Removing and replacing the control panel cable in the 7063-CR2
Learn how to remove and replace the control panel cable in the IBM Power Systems HMC (7063-CR2)
system.
Removing the control panel cable from the 7063-CR2 system
To remove the control panel cable from the IBM Power Systems HMC (7063-CR2) system, complete the
steps in this procedure.
Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
The ESD wrist strap must be connected to an unpainted metal surface until the service procedure is
completed, and if applicable, until the service access cover is replaced.
Attention:
• Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack,
or to an unpainted metal surface of your hardware to prevent the electrostatic discharge from
damaging your hardware.
Removing and replacing parts in the 7063-CR2 7