NOTE: Make sure that all empty slots are covered with blank panels before operating
the device.
Step 4: Connect the External Devices and IOC Cables
To connect external devices and IOC cables:
Figure 12: Connect External Devices and IOC Cables
Connect to a Network for Out-of-Band Management
1.
2.
Connect a Management Console
1.
2.
Connect to a Network for Out-of-Band Management on page 13
Connect a Management Console on page 13
Connect the IOC Cables on page 14
ALA RM
RE CO NS
OL E
SC B FRO
0
NT
0
PW R
HA RE AR
1
FA N
1
Plug one end of the RJ-45 Ethernet cable into the
Switch Fabric Board (SFB).
Plug the other end of the cable into the network device.
Plug the RJ-45 end of the serial cable into the
Fabric Board (SFB).
Plug the female DB-9 end into the device's serial port.
Step 4: Connect the External Devices and IOC Cables
RE ETHERNET 0
RE CONSOLE 0
Step 4: Connect the External Devices and IOC Cables
port on the
port on the Switch
13