Setting An Ip Address Using The Arp/Ping Command - Epson EPL-N2550 Network Manual

Setting an IP Address Using the arp/ping
Command
If you are using UNIX or OS/2, you need to use the arp and ping
command to set the IP address of the network interface. You can
also use these commands with Windows
Me/98/XP/2000/NT 4.0, if you have correctly installed TCP/IP
networking on these systems.
Note:
❏ Make sure that the Set using PING function is enabled on the
TCP/IP menu in EpsonNet Config. If this function is disabled, you
cannot set the IP address using the arp/ping command.
❏ Make sure the network interface and the computer are in the same
segment.
Before you start, you need the following information:
❏ A valid IP address for the network interface. Ask your
network administrator for an IP address which does not cause
conflicts with any other device on the network. If you are the
network administrator, choose an address within your subnet
which does not conflict with any other device.
❏ The MAC (Ethernet hardware) address of the network
interface. You can find out the MAC address on a status sheet.
Tips for Administrator
5
5
5
5
5
5
5
5
5
5
5
5
231