Chapter 2 How To; Overview - Epson EPL-N2550 Network Manual

Chapter 2
How To

Overview

This section describes the general procedure on how to set up the
network interface for use on a network.
1. Check the network interface operation.
Check the functions and operations of the network interface,
such as status lights and RJ-45 connector. See "Network
Interface Operation" on page 15 for details.
2. Select a printing method.
Select a printing method appropriate for your network
environment and operating system. If you are not sure, see
"Printing from Windows" on page 21 or "Printing from
Macintosh" on page 22 for details.
3. Install the necessary components on your computer.
Make sure the necessary components (such as TCP/IP,
NetBEUI, etc.) are installed on the computer, and network
settings (such as IP address, subnet mask, etc.) of the
computer is set. See "About Installing Components on Your
Computer" on page 25 for details.
4. Connect the network interface to the network.
Connect the network interface to the network. See
"Connecting the Network Interface to the Network" on page
41 for details.
19
How To
2
2
2
2
2
2
2
2
2
2
2
2