6. Press the Up or Down button until Get IP Address = Auto
appears. Press the Enter button and then the Up or Down
button to change to Get IP Address = Panel. Then press the
Enter button. You can use the following methods to get an IP
address.
❏ Choose Panel when setting the IP address, subnet mask,
and default gateway using the printer's control panel.
❏ Choose Auto when getting the IP address from a DHCP
server. The IP address is automatically obtained from the
DHCP server whenever the printer is reset or turned on.
❏ Choose PING when setting the IP address using the
arp/ping command. The network interface uses the IP
address set by the arp/ping command. The settings
become available when the printer is reset or turned off
and then back on.
Note:
❏ To use Auto, a DHCP server must be correctly configured on
the network. See the online help of your operating system for
detailed instructions.
❏ Choose PING only when setting the IP address using the
arp/ping command.
7. Press the Up or Down button until IP = xxx.xxx.xxx.xxx
appears. Press the Enter button.
8. Press the Up or Down button until the desired value appears.
Then press the Enter button to set the value.
Note:
Repeat steps 7 and 8 to set the IP address, subnet mask, and default
gateway.
9. Press the Start button to exit the control panel menus.
226
Tips for Administrator