Setting Up the Network Interface
Connecting the Network Interface to the
Network
Follow the instructions below to connect the network interface to
the network.
1. Make sure that your printer is turned off.
2. Connect one end of the network cable to the RJ-45 connector
on the network interface, and the other end to the network.
c
Note:
You can use both 10Base-T and 100Base-TX. When you print a lot
of data, we recommend you use a high-speed network of 100Base-TX
with a light network traffic.
3. Turn on your printer. After the status lights go off, print a
network status sheet.
c
Caution:
❏ You must use a Category 5 shielded twisted-pair cable to
connect the network interface to prevent malfunction.
❏ Do not connect or disconnect the network cable when the
printer is on.
❏ Do not connect the network interface and the computer
directly. Be sure to use a HUB to connect the network
interface to the network.
Caution:
After turning off the printer, wait until the status lights go
off before turning it back on; otherwise the network interface
may not work correctly.
41
How To
2
2
2
2
2
2
2
2
2
2
2
2