Arming The System - C&K systems System 236 Manual

TO ARM THE SYSTEM:
Make sure the display reads READY TO ARM.
.
.aulted zones must be cleared or bypassed before the system can be armed. If the
display reads NOT READY TO ARM, followed by .AULTED ZONE, push the # key. The
display will then indicate which zone(s) are faulted. .or more information, refer to the
sections Bypassing Zones and After An Alarm Occurs.
Enter your PIN and push the
PIN
REQUIRED
# key.
.
Don't pause for more than 5 seconds while entering the digits or the control panel will
reject your PIN number.
.
If you make a mistake while entering your PIN number, the keypad will beep five times.
After the fifth beep, enter your PIN number again.
236/236i
8
238/238i
PIN = 4 digits long
2316/2316i
PIN = 2 - 5 digits long
PIN = 2 - 5 digits long
#