Arming The System - C&K systems System 236i User Manual

TO ARM THE SYSTEM / AUTO HOME ARMING:
Make sure the green READY light is on.
.
Faulted zones must be cleared or bypassed before the system can be armed. For more
information, refer to the sections Bypassing Zones and After An Alarm Occurs.
OPTION
.
If programmed, the red ZONE lights will automatically turn off after five minutes (as a
INSTALLED
security measure). Pressing any key on the keypad will turn the ZONE lights back on.
Enter your PIN and push the
PIN
REQUIRED
# key.
.
Your PIN number is four digits long.
.
Don't pause for more than 5 seconds while entering the digits or the control panel will
reject your PIN number.
.
If you make a mistake while entering your PIN number, the keypad will beep five times.
After the fifth beep, enter your PIN number again.
Make sure the red ARM light comes on.
.
The keypad will beep twice to confirm that the system is armed.
9