Using the Command Summary
For the following commands that use only 0 or 1 for the variable,
either the decimal or hexadecimal values 1 and 0 or the ASCII
characters 1 and 0 can be used:
For example, in BASIC you can select draft mode with either of
these statements:
Control key chart
Some application programs can use control key codes for decimal
values 0 through
The Control Key column indicates that you press the control key at
the same time you press the key for the letter or symbol in that
column. For example, you press the control key and A at the same
time to send the value 1.
Note: Many programs use the control keys for other purposes.
Also, some programs do not use all these keys.
Hex
0
1
2
3
4
5
6
7
8
9
Command Summary
9-4
The table below gives you the proper values.
control key
A
I
control key
Hex
OF
0