Adjusting The Top Of Form Position - Epson DFX-8000 User Manual

Adjusting the Top of Form Position

The top of form position is the position the printer feeds the paper
to when it loads the paper or performs
important because it determines where the printing begins on each
page.
If the printing is too high or low on the page, you can reset the top
of form position by following the steps below. The printer
remembers the
turned off, reset, or initialized. (The printer remembers separate top
of form positions for the front and rear tractors.)
To temporarily change the top of form position, you can adjust the
position when the printer is not in top of form mode or you change
the printing position in the middle of a page as described in the next
section. The printer remembers the temporary top of form position
until the next time you load paper or switch tractors.
You can set the top of form position, from
22 inches (558.8 mm) below the top edge of paper. The factory
setting is the 0.2 inches (5.8 mm) position below the top edge of
paper.
WARNING:
enter top of form mode
adjust the top of form position when you are using labels,
use only the forward-feeding (top) MICRO FEED button.
Labels must never be fed backward through the printer.
See the section on adjusting the printing position in this
chapter.
CAUTION:
the format information about your multi-part forms, do
not try to adjust the top of form position.
new
top of form position even after the printer is
When labels are loaded in the printer, d o not
While using the paper memory feature to save
a
form feed. This position is
0.1
as
described in this section. To
Using the Printer
inches (2.6 mm) to
3-33