Table of Contents
Advertisement
SuperServer 5019P-M/MR User's Manual
DIMM Module Population Sequence
When installing memory modules, the DIMM slots must be populated in the following order:
DIMMA1, DIMMD1, DIMMB1, DIMME1, DIMMC1, DIMMF1.
•
Always use DDR4 memory of the same type, size and speed.
•
Mixed DIMM speeds can be installed. However, all DIMMs will run at the speed of the
slowest DIMM.
•
The motherboard will support odd-numbered modules (1 or 3 modules installed). However,
to achieve the best memory performance, a balanced memory population is recommended.
DIMM Installation
1. Insert the desired number of DIMMs into the memory slots in the order described above.
For best performance, please use the memory modules of the same type and speed.
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
3. Align the key of the DIMM module with the receptive point on the memory slot.
4. Align the notches on both ends of the module against the receptive points on the ends
of the slot.
5. Press the notches on both ends of the module straight down into the slot until the
module snaps into place.
6. Press the release tabs to the lock positions to secure the DIMM module into the slot.
DIMM Removal
Press both release tabs on the ends of the DIMM module to unlock it. Once the DIMM module
is loosened, remove it from the memory slot.
Notches
Release Tabs
Figure 3-1. Installing DIMMs
33
Press both notches
straight down into
the memory slot.
Advertisement
Table of Contents
