Supermicro SUPERSERVER 6018TR-T User Manual page 67

Connector Description
BT1 (Battery) Onboard CMOS battery (See Chapter 3 for Used Battery Disposal.)
COM1 Backplane COM Port1
FAN1,3,4 CPU/system fan headers (Fan 1, Fan 3, Fan 4)
Infi niBand Port Infi niBand FDR connector on the IO backpanel (Optional for the X10DRT-LIBF)
J4/J6 20-pin main power connectors (required)
JF1 Front panel control header
JIPMB1 4-pin external BMC I
JP3 4-pin power connector for the HDD panel on Chassis 808/809 (required)
JPI 2 C1 Power supply SMBbus I
JSD1/JSD2 SATA DOM (Disk-on-Module) power connectors 1/2
JSTBY1 Standby power connector
JTPM1 TPM (Trusted Platform Module)/Port 80 header
LAN1/LAN2 G-bit Ethernet (GLAN) ports 1/2
IPMI_LAN IPMI_dedicated LAN support by the ASpeed controller
I-SATA 0-5 SATA 3.0 connections supported by Intel PCH (I-SATA 0-5)
S-SATA0-3 SATA 3.0 connections (S-SATA0-3) supported by Intel SCU (Note: S-SATA2/S-
SATA3: can be used as Supermicro SuperDOMs (-Disks-on-Module) with built-in
power connectors)
I-SGPIO1/2 Serial General-Purpose Input/Out connector headers for I-SATA 0-5 (I-SGPIO1:
I-SATA0-3, I-SGPIO2: I-SATA4/5)
S-SPGIO1 Serial General-Purpose Input/Out connector header for S-SATA 0-3
(CPU1) Slot1 PCI-Express 3.0 x16 slot from CPU1 (JPICE1)
UID UID (Unit Identifi cation) switch
(BP) USB 0/1 (2.0) Backpanel USB 2.0 ports 0/1 (USB 0/1)
USB 2 (3.0) Type A USB 3.0 connector (USB 2)
VGA Backpanel VGA port
Chapter 5: Advanced Motherboard Setup
2
C header (for an IPMI card)
2 C header
5-15