SUPERSERVER 6018TR-T/TF User's Manual
sSATA Port 0~ Port 3
Select Enabled to enable an sSATA port specifi ed by the user. The options are
Disabled and Enabled.
sSATA Port 0 ~ Port 3 Hot Plug
This feature designates this port for hot plugging. Set this item to Enabled for
hot-plugging support, which will allow the user to replace an sSATA drive without
shutting down the system. The options are Enabled and Disabled.
sSATA Port 0 ~ Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a
COMRESET initialization to the device. The options are Enabled and Disabled.
Port 0 ~ Port 3 sSATA Device Type
Use this item to specify if the sSATA port specifi ed by the user should be
connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
Server ME (Management Engine) Confi guration
This feature displays the following system ME confi guration settings.
•
General ME Confi guration
•
Operational Firmware Version
•
Recovery Firmware Version
•
ME Firmware Features
•
ME Firmware Status #1
•
ME Firmware Status #2
•
Current State
•
Error Code
PCIe/PCI/PnP Confi guration
The following PCI information will be displayed:
•
PCI Bus Driver Version
•
PCI Device Common Settings
7-20