Page 1
Four Port oMG Quick Set-Up Guide 4119612 Rev 1...
Page 2
Notice totally lost. Although significant delays or losses of data are rare when wireless devices such as the Sierra Wireless modem are used in a normal manner with a well-constructed network, the Sierra Wireless modem should not be used in...
Table 1-1: Related Publications Title and Publication Number Description 4119192 oMG 2000 Installation Guide Describes how to install the oMG in a vehicle. 4118621 SIM Card Installation Guide Describes how to install SIM cards into an oMG. 4118618 oMG Operation and Provides detailed information about the operation Configuration Guide 3.14...
2: Before You Begin You must have the following: • Carrier-activated mini-SIM card. Note that a mini-SIM is required and has a different sizing compared to other SIM card types, as shown in Figure 2-1 below. • Miscellaneous equipment: · Screwdriver—#1 Phillips Figure 2-1: Comparison of SIM Card sizes Rev 1 Jul.16 4119612...
3: Check Your Package Contents The following items are included with your oMG (may be separately boxed): • oMG base unit • WAN/GPS antennas (optional) • DC power cable • AC power cable adapter (optional) • WAN cable adapter • Wi-Fi antenna Rev 1 Jul.16 4119612...
4: Install the SIM Card into the oMG Warning: Use ESD protection including a grounded wrist-strap. 1. Open the center cover by unfastening the four Phillips screws using a #1 Phillips screwdriver. 2. Insert the SIM card as follows: a. Use the screwdriver to push the SIM tray eject button. b.
5: Install the oMG 1. If you are bench testing using the optional AC adapter, proceed to Chapter 7 on page 2. Mount the unit inside the vehicle in a waterproof area using its mounting holes. Be sure there is 3.5 inches clearance as shown in Figure 5-1.
Install the oMG 3. Wire the cable-end of the DC power cable into the vehicle’s electrical system. Figure 5-2: DC Power Cable Wiring 4. Attach the following cables to the ports on the rear of the oMG as shown in Figure 5-3 below: a.
6: Power Up the oMG and Connect the 1. Power on the oMG. This may require you to turn on the ignition in the vehicle. Warning: Do not power down without following proper procedures (see Chapter 9 on page 15). 2.
7: Log in to the oMG 1. Open your web browser (e.g. Firefox, IE, or Safari) and start the Local Configu- ration Interface (LCI) by typing the following into the browser address bar: http://welcome.to.inmotion/MG-LCI. Figure 7-1: oMG LCI Login Screen 2.
8: Testing the Installation The oMG is pre-configured with settings for the Verizon public LTE network. After powering on the oMG, the Green LED indicator will blink until it connects to the WAN. When the Green LED is on solid, the WAN connection is operational. If the Green LED continues to blink: 1.
PC). Warning: Sierra Wireless does not recommend powering down the oMG unexpectedly. When wired correctly, turning the ignition off will cause the oMG to perform a graceful shutdown. To manually power down the oMG: 1.
A: PC Setup for Dynamic IP Addressing The following steps describe how to set up IP addressing on Windows XP. For other operating systems, consult your OS documentation. 1. Navigate to Start, right click My Network Places, and select Properties. 2.
Need help?
Do you have a question about the oMG 2000 and is the answer not in the manual?
Questions and answers