ITR Hurricane Zephyr HW Installation And Operating Manual page 57

Section 9, Operation
burner). An integral, adjustable water tempering valve (factory pre-
set), will limit the temperature to 120F.
• Easy to install and field serviceable with hookups and connections
easily accessible from the top of the heater. Engine coolant
connections are made from the back of the heater.
• Easy to fill and purge and drain.
• Zero pressure system; no need for a separate expansion tank.
• A high-temperature, stainless steel burner and stainless-steel
transfer fluid jacket.
• Unique, self-purging, 2 US gallon, welded and insulated stainless
steel transfer fluid tank that minimizes heat loss and optimizes heat
recovery.
• Quiet operation.
• Low pressure fuel system with built-in fuel pump.
• Fuel efficient burner capable of burning a wide variety of diesel-
based fuels (CSA/UL certified for diesel #1 and #2).
• Exhaust has minimal smoke and smell.
• Fan assisted, sealed combustion chamber is designed to use
outside combustion air.
• Simple, low amperage draw ignition.
• Electronically-controlled system with automatic safety Shutdown
• Manual-resettable aquastat for safety overheat protection.
• Patented, proprietary flame sensor.
• Touchscreen remote control
• System control panel with LED fault indicators, operational and
diagnostic information.
The initial start of your Hurricane® Zephyr™ HW heater must be
done by an authorized service person. Be sure that all components
have been properly installed according to the instructions laid out in
this manual before the initial start.
9-2 Installation Manual for Hurricane® Zephyr™ HW Heating System