Step 5: Backplane Installation - Acnodes RMC8416 Installation Manual

The PSU is installed at the rear of the chassis. The PSU
is secured to the chassis with an internal PSU securing
clamp and 4 retention screws from the rear of the chassis.
To install the PSU, please follow the steps below:
Step 1: To remove the PSU securing clamp, remove the
2 PSU securing clamp retention screws.
Figure 7: PSU Securing Clamp Retention Screws
Step 2: Correctly position the PSU at the rear of the
chassis making sure that the power switch and the cable
socket both face outwards.
Step 3: Once the PSU has been correctly positioned,
secure the PSU to the chassis by inserting 4 retention
screws through the rear of the chassis.
Figure 8: Insert PSU Retention Screws
Step 4: Reinstall the PSU securing clamp and
reinsert the 2 previously removed PSU securing
clamp retention screws.
15-inch touch panel PC

STEP 5: BACKPLANE INSTALLATION

The IEI backplanes listed below are compatible with the
RMC 8416 chassis.
Table 3: Compatible Backplanes
To install a compatible backplane please follow the
instructions below:
Step 1: Insert the copper pillars in the predrilled screw
holes in the bottom of the chassis according to the
distribution of the retention screw holes in the backplane
you want to install.
Figure 9: Locations of the 9 Copper Pillars
Step 2: Mount the backplane onto the copper pillars and
align the backplane screw holes with the screw holes in
the copper pillars.
4