Acnodes RMC8416 Installation Manual page 3

STEP 3.2: HOLD-DOWN CLAMP REMOVAL
Detach the hold-down clamp by removing the 2 screws located on each side of the chassis and lift the hold-down clamp off
the chassis.
Figure 5: Remove the 2 Hold-Down Clamp Retention Screws
Figure 6: Lift the Hold-Down Clamp off the Hold-Down
Clamp Securing Hook
STEP 4: Install the Power Supply Unit (PSU)
Once the top cover and hold-down clamp have been removed, the PSU must be installed. Compatible IEI PSUs are listed in
the table below.
Table 2: Compatible IEI PSUs.
3