Table of Contents
Advertisement
INSTALLATION STEPS
To install the RMC 8416 chassis, the following installation
steps must be completed:
Step 1:
Unpack the chassis.
Step 2: Install the front handles.
Step 3: Remove the top cover and hold-down clamp.
Step 4:
Install the PSU.
Step 5:
Install the backplane.
Step 6:
Install the CPU card.
Step 7: Install the PCI and ISA expansion cards.
Step 8:
Install the disk drives.
Step 9: Connect front panel cables.
Step 10: Connect PSU cable and interface cable.
Step 11: Install the hold-down clamp and PCI/ISA
card shock absorbers.
Step 12: Reinstall the top cover.
The installation steps outlined above are described in
detail below. Please refer to the relevant section.
STEP 1: UNPACK
The RMC 8416 is shipped in a plastic bag that is placed
inside a cardboard box. The items are also shipped with
the chassis. When you unpack the chassis you must:
Make sure all the items listed above are present.
Make sure the chassis has not been damaged in any
way.
STEP 2: FRONT HANDLE INSTALLATION
Two handles are shipped with the RMC 8416 chassis. The
handles are installed on the sides, at the front of the
chassis. Each handle is secured to the chassis by 4
retention screws. To install the handles, please follow the
steps below:
Step 1: Align the retention screw holes on the side of the chas-
sis with the retention screws in the handle.
Step 2: Insert 4 retention screws for each handle.
Figure 2: Insert 4 Front Handle Retention Screws
STEP 3: TOP COVER AND HOLD-DOWN CLAMP REMOVAL
3.1: TOP COVER REMOVAL
The top cover is secured to the chassis with 6 retention screws,
three on each side of the chassis. To remove the top cover, please
follow the steps below:
Step 1: Remove all 6 top cover retention screws. Remove 3
retention screws from each side of the chassis.
Figure 3: Top Cover Retention Screws
Step 2: Slide the top cover backwards and Lift the top cover up
gently.
2
Advertisement
Table of Contents
