Table of Contents
Advertisement
Step 4: Reinsert the 2 previously removed side bracket
retention screws into the top of the side bracket.
STEP 9: CONNECT FRONT PANEL CABLES
The RMC 8416 has LEDs, buttons and ports on the front
bezel.
o
1 x Power LED
o
1 x HDD activity LED
o
1 x Power switch
o
1 x Reset button o
These components are all connected to the CPU card with
cables. To correctly connect these cables, please refer to
the technical documentation that came with your CPU
card. The connectors that are provided with the chassis
are listed below.
Table 4: Chassis Connectors
2 x USB ports
The pin definitions for the USB cable are shown below
STEP 10: PSU CABLE AND INTERFACE CABLE CON-
NECTIONS
Before you reinstall the hold-down clamp and the cover,
the following cables need to be connected.
Step 1:
Connect the PSU cables from the PSU to the
backplane, full-size CPU card, HDD, FDD, cooling fans
and optical drives power connector.
Step 2: The drive interface connectors must be con-
nected to the CPU card.
STEP 11: HOLD-DOWN CLAMP AND PCI/ISA CARD
SHOCK ABSORBERS INSTALLATION
The RMC 8416 comes with 9 shock absorbers, 2 long
shock absorbers and 7 short shock absorbers, used for
securing the PCI/ISA cards from vibration. Because the
shock absorbers are attached to the hold-down clamp, the
shock absorbers should be installed after hold-down
clamp is reinstalled. To install the hold-down clamp
and shock absorbers, please follow the steps below:
Step 1:
Slide the end of the hold-down clamp with 2
holes for the hold-down clamp hooks into the hold-down
clamp securing hook on the right side of the chassis.
Step 2:
Align the retention screw holes in the other
end of the hold-down clamp with two retention screw holes
in the clip stretches out from the internal side HDD
bracket.
8
Advertisement
Table of Contents
